A 0.185H inductor is connected in series with a 99 Ohm resistor and an ac source. The voltage across the inductor is vL = -(11.5V)sin[(470rad/s)t]. Derive an expression for the voltage vR across the resistor. What is vR at 1.85 ms?
Q: a) How many essential nodes does the circuit have? b) Which nodes are not connected to each other?…
A: For the given matrix form of an electrical network the number of essential nodes, the number of…
Q: 120 VRMS my What is the secondary voltage if the turns ratio is 1:3? Select one: OA. 360 VRMS OB. 40…
A: Given Data:An ideal step-up transformer with,Primary voltage Turns ratio To Find:The secondary…
Q: A coil of inductance 200µH and resistance 50.27ohms and a variable capacitor are connected in…
A: Given:In a sereis RLC circuit,inductance L=200µHresistance, R=50.27ohm and a variable capacitor.…
Q: For the circuit below, compute the input power, Pin; insertion loss in dB and complex (phasor)…
A:
Q: In a 208-V, three-phase motor load, the current drawn by the motor is 25 A, and the PF is 0.87. What…
A:
Q: Find the total 3 phase complex power, average power, reactive power, apparent power and power factor
A: The circuit diagram,The voltages which are given are phase voltages and assuming the voltages given…
Q: 3.35 For the transistor in the circuit in Figure P3.35, the parameters are 120 μA/V2, and W/L = 25.…
A:
Q: The voltage source has a output voltage Us of 230 V. Each light bulb requires 115 V. However, the…
A: Given circuit,
Q: You have a project to build a new fence. The fence is four sided as shown below. Each side is to…
A: The objective of the question is to analyze the project status chart and determine the current…
Q: k2. The BJT has ß-100. Determine the maximum allowed input amplitude for linear behavior. Enter your…
A: To determine the maximum allowed input amplitude for linear behavior in a common emitter amplifier,…
Q: Q10. For the noninverting amplifier illustrated below, what is? a) The closed loop gain b) The…
A:
Q: X (0) 27C8(w-kwo)
A: Given:we have to find:Inverse Fourier transform.
Q: Find the Absolute Bandwidth, Null to Null Bandwidth and 3 dB Bandwidth of the following signal
A: According to the question, for the given circuit as shown belowWe need to find absolute Bandwidth,…
Q: Q1: Based on the code bellow, answer the following questions: (answer 3 of the following) A- By the…
A: According to the question, we need to execute the given program as shown belowLDR R1, #2008MOV RO,…
Q: Subtract the following unsigned binary numbers. a. 1100-100 b. 10001 - 1001 c. 101011100 d.…
A:
Q: The switch had been in position 1 for a long time before it was moved to position 2 at t=0. The…
A: In the given questions we need to calculate the voltage across capacitor.
Q: With respect to attached circuit: a. Use Thevenin's theory to determine the correct wattage rating…
A: The circuit is given ashere
Q: Use Kirchhoff's circuit laws to calculate Up. τ 10 Ω 20 Ω + Up 50 Ω 25 Ω 5A 4A 5Ω 100 Ω 10 Α
A: Given Data:A DC resistive circuit with the mesh currents as,To Find:The value of the voltage .
Q: (a) Determine the resonant frequency, fr, for this circuit. (b) Calculate the impedances, Z₁ and Z2,…
A: The RLC circuit is given ashere
Q: ZT- Z₁ www R = 60 2₂ Z3 moo HE X = 10 Ω _ Xc = 12 Ω The angle of the total impedance is.......…
A: Given Data:An RLC series circuit with,Resistance Inductive reactance Capacitive reactance To Find:…
Q: 花咕咕 clk T 22 品 yDo of Q1 HO clk 1 200 D1 61 elk 02 02 -fclk 3பரபபபபாட
A:
Q: A system is described by the differential equation (see attached). a)What is the order of the…
A: The differential equation is given as
Q: Solve the circuit by hand for nodes/supernodes, and find Ix
A: The circuit diagram is shown below,
Q: B) Determine the signal corresponding to each of the following transforms: 1) X(e) = 1 + 3e-jw…
A:
Q: LTI application Find if it's And if it's Cos (t). nct) ylt] Linear / Non Linear system Time…
A: Given:a system, we need to find whether the system is:a) Linear or non-linearb) Time invariant or…
Q: A three-term averaging filter is applied to the x[n] values in Table 1. Assume that prior to n = -2,…
A: Given:A three term averaging filter, in which prior to n=-2, x[n]=0, we need to write the equation…
Q: Determine I1, I2, and I3 for both circuits shown Please answer in typing format please ASAP
A: The circuit diagrams,
Q: Consider the circuit on the right, the resistors all have a resistance R. The equivalent resistance…
A: Given circuit,Value of resistances = RAsked to find the resistance seen by the voltage source?
Q: An input voltage of 230 V is applied to a step-up chopper and the output voltage is 690 V. The pulse…
A:
Q: Get the fourier transform of f(t-a)u(t-a)
A:
Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…
A:
Q: Use Norton's theorem to find Vo in the circuit of the figure. Take R = 4 ΚΩ. 12 ΚΩ www 36 V 24 ΚΩ…
A:
Q: Q1) In Figure below(a), a system is shown with input signal x(t) and output signal y(t). The input…
A: Given:we need to determine and sketch Y(jw), the spectrum of y(t).
Q: You have a project to build a new fence. The fence is four sided as shown below. Each side is to…
A: The objective of the question is to calculate the additional cost that will be incurred if the…
Q: Find the Voltage from node n1,n2,n3,n4,n5
A: The given circuit isWe need to determine the voltages at nodes n1, n2, n3, n4 and n5.
Q: B) With the knowledge of DFT values at even indices of a 7-point real sequence: X(0) = 3.6; X(2) =…
A:
Q: : Fill in only five of the following with a short answer 1. It can assign solution type (minimum or…
A: Some statements are given with blanks. We need to fill the blanks with appropriate answers and also…
Q: Exercise 1: A d.c. shunt-wound generator rated at 220 V and 40 A armature current has an armature…
A: Given information is shown below:To find:
Q: Q1) In Figure below(a), a system is shown with input signal x(t) and output signal y(t). The input…
A: Given:we need to do:Determine and sketch Y(jw), the spectrum of y(t).
Q: Find the base current IB.
A:
Q: Calculate the guided intrinsic impedance at 20 GHz for the lowest-order mode of the rectangular…
A: The objective of this question is to calculate the guided intrinsic impedance for the lowest-order…
Q: Problem 2: Question Consider the circuit below: R2 2 ΚΩ R1 1 ΚΩ R3 5 ΚΩ IS1 50 mA E1 20V R4 4 ΚΩ E2…
A: Current through R4 by superposition theorem
Q: Q3: "Beam forming" is a technology that is reportedly a feature of what other technology? A. QAM B.…
A: In the given questions we need to explain about Beam forming.
Q: Find resistor Volve RiF Power disappointed in 52 resistor TS 2ow 17V +1 K Sn
A:
Q: 1. For the ADC0804 used in section 1. the step size can be adjusted by setting the reference voltage…
A: The objective of the question is to understand the operation of ADC0804 and D/A converter, and to…
Q: Apply Kirchhoff's laws to find 13 in the circuit shown in Fig. 2. R₁ www 202 E₁ 10 V R₂ MIN R₂ ww 40…
A: Kirchhoffs voltage law (KVL) states that sum of voltage in a loop is zero.Kirchhoffs current law…
Q: Define each function as even, odd, or neither. Justify your answers. (i) f(x)=e* (ii) f(x) = x²…
A:
Q: Q3. Find the Thevenin equivalent circuit external to RL from the network shown in Figure 3.1 below.…
A: The circuit is given aswe need to calculate the thevenin equivalent across ab terminal.
Q: Solving for R using the Discharging curve equation: V(t) = 1.83V Vc = 4.96V C =4.7uF T = 50s V(t) =…
A: A RC circuit having V(t)=1.83 V.VC=4.96 V.C=4.7μF.T=50s.We need to determineThe value of R.The value…
Q: You are given the following balanced three-phase circuit. L1 L2 L3 N U₁ (-2,-3) U₂ 7.2 The current…
A: The given circuit diagram is shown below.The above three-phase circuit is balanced.
A 0.185H inductor is connected in series with a 99 Ohm resistor and an ac source. The voltage across the inductor is vL = -(11.5V)sin[(470rad/s)t]. Derive an expression for the voltage vR across the resistor. What is vR at 1.85 ms?
AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.
Unlock instant AI solutions
Tap the button
to generate a solution
Click the button to generate
a solution
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
- A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads. An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of voltage in the circuit4. The current through a 10-mH inductor is 10e“²A. Find the voltage and the power at t = 3s. Ans.-11.16 mV and -24.89mW
- A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7An AC voltage source is connected to a circuit. The current in the circuit leads the voltage by 90°. The circuit comprises of a: Select one: A. Pure inductor B. Inductor with resistor C. Pure capacitor D. Capacitor with resistorA capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
- A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltageAn inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductorFind the equivalent inductance as seen from the terminals shown in the figure.