A resistor and a capacitor areconnected in series across a supply of250V. When the supply frequency is50HZ, the current in the circuit is 5A.When the supply frequency is 60HZ,the current is 5.5A. Find the value ofthe capacitance.96.436 microfarad43.966 microfarad34.696 microfarad63 943 microfarad69 436 microfarad36.496 microfarad

Given The resistor and capacitor are connected in series Supply voltage V=250 v frequency is 50 Hz…

Answered: A resistor and a capacitor are…

A resistor and a capacitor are connected in series across a supp 250V. When the supply frequency 50HZ, the current in the circuit is 5 When the supply frequency is 60H

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: A vector field eat Find the vector field intensity e point. c,3,5) a. 16.9 b. 14.99 C. 12.49 d. 10.4...

Q: 1) What is meant by measurement? 2) What are the basic requirements of measurement? 3) State the two...

Q: Q1 – For the circuit of Figure below: a) Determine Thevenin equivalent circuit at the output termina...

A: Thevenin's Theorem is a strategy for converting a circuit (usually a complicated one) into a simple ...

Q: When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1.325 A. Wh...

A: The solution is given below

Q: Vector Field C= «ty)ax+ xay +Cy+ZJQz D= (2ty)ax+ Yay t (xtD az A+B = ? a-(2x +ytz Jaxt+ (+2yayt b-(x...

A: The solution is given below

Q: QUESTION 37 For the step down transformer below the turns ratio is 9:1, the primary voltage is 88 V ...

Q: 13) In a PNP circuit, the collector is positive with respect to the emitter. 14) The output is in ph...

A: I am attaching detailed solution image of this question.

Q: 1. A wye connected load has a 5 < 20° ohm impedance per phase and is connected across a 120 V three ...

A: In this question star connected load is given with phase impedance and line voltage....We have to fi...

Q: 1 Ohm 2 Ohms 4 Ohms 4 Ohms ELECTONICS HU acov A07 H Ohms m

Q: 1. The electric field intensity vector of a uniform plane electromagnetic wave is given a E(x,t) =10...

A: Note : We are authorized to answer three subparts at a time, since you have not mentioned which par...

Q: Vector A=3 Gx +4 cy +5ậi BE Sâx - Gây-3ấz find AX B a Jaxt 3tag-3392 c 17axt>tag-56a2

A: In this question we need to find a cross product of two vector field.

Q: The emitter current and the base current of a npn BJT are 1.46 mA and 14.46 µA respectively. Calcula...

A: Given, Emitter current, IE = 1.46 mA Case current, IB = 14.46 μA = 0.01446 mA Saturation current, Is...

Q: A certain series RL ac circuit has an instantaneous power of p(t) = 125 + 250 cos 240xt. Find the po...

Q: Apply Bilinear transformation to H()=8/[(s+3)(s+4)] with T=0.5s. Find H(z). Realize the filter with ...

A: Hs=8s+3s+4Hs=8s2+7s+12 Putting values of s as, s=2TZ-1Z+1 And, T=0.5

Q: Essay 1. Discuss how electric circuits can be understood in relation to water flowing in pipes.

A: The electric circuit can be understood in relation to water flowing in pipes: The pump drives the wa...

Q: 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequenc...

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle source is then...

Q: Most Digital transmission are "self-clocking "in that they derive the bit synchronization fror the s...

A: We know, Most of the digital transmissions are "self-clocking," meaning that the bit synchronization...

Q: A coil has a resistance of 24 Ω at 50°C and 32 Ω at 120°C. Find the resistance at 0°C and the temper...

Q: 57 V 42 V 幸V 25 V幸 70 V

Q: Question 6 Two conducting cylinders at p= 2 cm and p = 8 cm in free space are held at potentials of ...

A: Here, we have given two conducting cylinders, for which the 'ρ' is varying. So, we will perform inte...

Q: 5. Develop an assembly language program that continuously gets 8 bit data from P0 and sends it to P1...

A: Program-

Q: A 100-mH inductor is connected in parallel ta

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 2...

Q: What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10 cos2...

A: It is given that: C=20 μFE=10cos2377tt=1 sec

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-c Source is then imp...

Q: 1. A wye connected load has a 5 < 20° ohm impedance per phase and is connected across a 120 V three ...

A: There are two ways to link a three-phase load in a three-phase system.1. Wye/Star Connection 2. Conn...

Q: Homework 3 – ECE 403 Problem 1: Solve the DC operating points of the following circuits. • Calculate...

Q: A coaxial cable has a 10-mm diameter inside conductor and a metallic sheath with an inside diameter ...

Q: Each subsatnce absorbs or emit unoque level & quantities of energy/ e.m.r.. True False

A: GIVEN: a statement FIND: TRUE OR FALSE

Q: 7. The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to op...

Q: Determine the maximum number of lighting outlets for 15, 20, 25 and 30 circuit breaker

Q: 1 Ok 2 Oh :4 Oks ELECTONICS Jacov

A: The given circuit diagram is shown below:

Q: Determine the simplified expression for F(A,B,C,D) using K-Map

Q: Vhat happened to 3-phase delta configuration of transformer when any one of the phases s opened due ...

A: A three phase transformer, also known as a 3 transformer, can be built by connecting three single-ph...

Q: R5 R2 1kn 10KA R. 10 KA R6 U2 1 KA U1 100 A Ci C2 Vi 1 pf 1yf R3 a) find the gain and fol and fom fo...

Q: 1. The armature windings of a dc motor have a resistance of 5.0 Ω. The motor is connected to a 120 V...

Q: Problem 5 C(s) R(s) + -15

Q: A wire carries a current i = 3cos314t A. What is the average current over 6 seconds?

A: Average value of a function f(t) with a period T = 1T∫0Tf(t)dt

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The circu...

A: In this question, Determine the apparent power? We know apparent S= VI* I* is conjugate of the c...

Q: 1.35. Carefully sketch each signal described below. x[n] = {1, -1, 3, -2, 5} a. %3D | T[n] = (0.8)" ...

Q: For the signal, x(t), shown in the figure below 4 x(1) 3 1 | [sec] 2 Find the following at t = 4 sec...

Q: A 1500 W portable heater will use 1.5 kW per hour. In 4 hours, it would use _______ Horsepower

Q: For the circuit below, find

Q: 1. Find voltages Va, Vp, and V. and currents i, i2, iz, i4, and is. Use substitution method. 2.2kN 1...

A: Note : In the given circuit diagram Va, Vb and Vc are not mentioned so considering the bulleted poin...

Q: Find an given A- [2x+y?) art Czy ay-Xaz Czxty )an t 6 Xyzay -x*az a.

A: In this question we need to find a unit vector aA .

Q: Problem 3: For the system with the block diagram shown in Figure 3, assign conditions on control gai...

Q: certain p(t) = 125 + 250 cos 240rt. Find the power factor. A series RL ac circuit has an instantaneo...

A: We need to find out power factor for RL circuit

Q: In a BJT, the value of IC=188mA and IB=0.054mA. Solve for IE in mA.

Q: 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequenc...

A: We have given the resistor and capacitor are connected with supply which is 250 V where in first ca...

Question

A resistor and a capacitor are
connected in series across a supply of
250V. When the supply frequency is
50HZ, the current in the circuit is 5A.
When the supply frequency is 60HZ,
the current is 5.5A. Find the value of
the capacitance.
96.436 microfarad
43.966 microfarad
34.696 microfarad
63 943 microfarad
69 436 microfarad
36.496 microfarad

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
List the five capacitor replacement rules.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Solve for the total capacitance of the circuit. Select one: a. 5.28 micro Farads b. 6.64 micro Farads c. 8.42 micro Farads d. 5.92 micro Farads
By convention, the sign of reactive power to an inductance is and the sign of reactive power to a capacitance is
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
The attached image shows a circuit with an AC voltage source, a resistor, inductor, and capacitor connected in series. The circuit has the following characteristics: Resistor resistance: 10 ohm Capacitor capacitance: 0.05 F Inductor inductance: 13 H Current Amplitude: 4 A Voltage amplitude across the source: 60 V Frequency at the source: 0.3 Hz Voltage amplitude across the resistor: 35 V Voltage amplitude across the capacitor: 37 V Voltage amplitude across the inductor: 80 V (a) Calculate the RMS voltages from the amplitudes above. From the RMS voltages across the capacitor, inductor and resistor, calculate the RMS voltage of the AC source. Hint: Vrms = V0/sqrt(2) Vrms = sqrt( (Vrms,R)2 + (Vrms, L - Vrms, C)2 ) (b) Calculate the RMS value of the current (c) Using the resistance, capacitance, inductance, and the frequency of the AC voltage, calculate the impedance Z. From this, and the previously measured value of Vrms, find the RMS value of the current in the circuit.