In the engine shown above, 0.213 moles of a monatomic ideal gas goes through the following processes: • 1-> 2: Isothermal expansion at TH = 603 K ● 2 -> 3: Constant pressure compression • 3-> 1: Increase in pressure at constant volume Assume that V₂ = 3.12 V₁. What is the total work done by this engine in one cycle? Give your answers in Joules to three significant figures, but don't include the units in your answer. Р TH

In the engine shown above, 0.213 moles of a monatomic ideal gas goes through the following processes: • 1-> 2: Isothermal expansion at TH = 603 K ● 2 -> 3: Constant pressure compression • 3-> 1: Increase in pressure at constant volume Assume that V₂ = 3.12 V₁. What is the total work done by this engine in one cycle? Give your answers in Joules to three significant figures, but don't include the units in your answer. Р TH

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 86AP: Five moles of a monatomic ideal gas in a cylinder at 27 is expanded isothermally from a volume of 5...

See similar textbooks

Similar questions

When a gas expands along AB (see below), it does 500 J of work and absorbs 250 J of heat. When the gas expands along AC, it does 700 J of work and absorbs 300 J of heat. (a) How much heat does the gas exchange along BC? (b) When the gas makes the transmission from C to A along CDA, 800 J of work are done on it from C to D. How much heat does it exchange along CDA?
A dilute gas expands quasi-statically to three times its initial volume. Is the final gas pressure greater for an isothermal or an adiabatic expansion? Does your answer depend on whether the gas is monatomic, diatomic, or polyatomic?
Five moles of a monatomic ideal gas in a cylinder at 27 is expanded isothermally from a volume of 5 L to 10 L. (a) What is the change in internal energy? (b) How much work was done on the gas in the process? (c) How much heat was transferred to the gas?
An ideal gas at temperature T is stored in the left half of an insulating container of volume V using a partition of negligible volume (see below). What is the entropy change per mole of the gas in each of the following cases? (a) The partition is suddenly removed and the gas quickly fills the entire container. (b) A tiny hole is punctured in the partition and after a long period, the gas reaches an equilibrium state such that there is no net flow through the hole. (c) The partition is moved very slowly and adiabatically all the way to the light wall so that the gas finally fills the entire container.
One mole of an ideal gas is initially in a chamber of volume 1.0102 m3 and at a temperature of 27 . (a) How much heat is absorbed by the gas when it slowly expands isothermally to twice its initial volume? (b) Suppose the gas is slowly transformed to the same final state by first decreasing the pressure at constant volume and then expanding it isobarically. What is the heat transferred for this case? (c) Calculate the heat transferred when the gas is transformed quasi-statically to the same final state by expanding it isobarically, then decreasing its pressure at constant volume.
It is unlikely that a process can be isothermal unless it is a very slow process. Explain why. Is the same true for isobaric and isochoric processes? Explain your answer.
A tank contains 111.0 g chlorine gas l2), which is at temperature 82.0 and absolute pressure 5.70105 Pa. The temperature of the air outside the tank is 20.0 . The molar mass of Cl2 is 70.9 g/mol. (a) What is the volume of the tank? (b) What is the internal energy of the gas? (c) What is the work done by the gas if the temperature and pressure inside the tank drop to 31.0 and 3.80105 Pa, respectively, due to a leak?
When a gas expands isothermally, it does work. What is the source of energy needed to do this work?
4 moles of an ideal monatomic gas undergoes the three process cycle as depicted in the figure below. The cycle is composed of an isobaric, isovolumetric, and isothermal process. P. P. V V. For the given parameters p,=p,=9.10* Pa and V,= 1.1 m3, V,= V.=0.55 m3 calculate the following. (Take the universal gas constant as R= 8.314 J.mol-1.K-1 a) The pressure pc = Pa b) The net work done by the gas Wnet = c) The heat entering the cycle QH = d) The thermal efficiency of the cycle (in percent): e = %
2 points Save Answe A 2.00-mol sample of a diatomic ideal gas expands slowly and adiabatically (y = 1.4) from a pressure of 5.00 atm and a volume of 12.0 L to a final volume of 30.0 L. Find the work done (in kJ ) on the gas. -4.66 -0.55 -2.33 -1.50 -4.44
0.5 mole of an ideal monatomic gas starts from 500 point a in the diagram to the right. It undergoes a a b 400 constant pressure expansion from a to b; a constant volume compression from b to c: and an isothermal a200 compression from c to a. 200 From last week, find the three temperature values Ta, To and T. and the total work for one cycle W. Now find the heat added along the three processes 100 Qab, Qbc and Qca and the efficiency of this process. 2 4 Find the change in entropy along each process Sabı Spc and Sca and the total entrophy change. volume (m³) pressure (Pa)
The heat of melting of ice at 1 atmosphere pressure and 0°C is 1.4363 kcal/mol. The volume of ice is 0.0196 liter and the volume of water is 0.018 liter. If 1 mole of ice is melted under these conditions, what will be a. The work done in cal? b. The change in internal energy in cal? The change in entropy in cal? Note that 1 literxatmosphere is equal to 101.325 joule. Please solve with clarification of laws and with the order of units [Cal]