iscuss the relationship between the building form and wind

Q: A 6-in.-diameter concrete test cylinder is loaded with a compressive force of 113.1 kips, as shown…

A: Given data :The value of compressive force (F) = 113.1 kipsThe value of diameter of concrete…

Q: Q3) A closed 0.4 m diameter cylindrical tank completely filled with oil (SG=0.9) rotates about its…

A: D = 0.4 m SG = 0.90 = 40 rad/s

Q: 2. The average wastewater flow from a community of 20,000 is 125 gpcd. The 5 day, 20 deg C BOD is…

A: Population = 20000To Find:1) Settling tank surface area2) Settling tank diameter3) BOD removal in…

Q: A column member with Lcx=Lcy=15 ft must resist an ultimate LRFD strength of Pu=500 kip. 1. Select…

A: Lcx=Lcy=15 ftultimate LRFD strength of Pu=500 kip*Note: As per Bartleby's guidelines we are supposed…

Q: Solve for forces in joint D

A:

Q: A rough brick circular sewer 72 inches in diameter with n =0.020 ,is to have a slope of 0.0009.…

A: Diameter of the circular sewer (D): 72 inchesManning's roughness coefficient (n): 0.020Slope of the…

Q: In the image, w = 300 N/m. a) Determine the shear force at point E of the frame. Express your…

A: The free body diagram of the frame can be drawn as:The support reactions can be determined by using…

Q: Assume a pressure load "p," is applied on the entire framing plan shown below. Show the equivalent…

A:

Q: settling tank has an overflow rate of 100,000 gal/ft^2 •d. Water carrying sediment of various sizes…

A: Overflow rate = 100,000 gal/ft2settling velocitymass friction…

Q: 3.82 A crane column supports a 16-kip load as shown. Replace the load with an equivalent system…

A:

Q: The toggle-wedge is an effective device to close the gap between two planks during construction of a…

A:

Q: 2. The average wastewater flow from a community of 20,000 is 125 gpcd. The 5 day, 20 deg C BOD is…

A: Population = 20000To Find:1) Settling tank surface area2) Settling tank diameter3) BOD removal in…

Q: Calculate the omitted lengths of the lines of BC and CD of a closed traverse ABCDEA, using the…

A:

Q: A 30 m-long precast concrete pile with diameter of 0.4 m in driven in to a thick dry sand layer. The…

A: L = 30 m D = 0.4 m = 17 kN/m3  = 36o

Q: The storage-outflow characteristics for a reservoir are given below. Storage (106 m³) 70 80 85…

A: To find:graph of storage outflow function

Q: 4. In a plane wave front, the pressures in the plane of the wave front are v/(1-v) times the…

A:

Q: what are the effects of aggregates in the performance of concrete?

A: ‘Aggregate’ is a term used for any particulate material that may  includes gravel, crushed stone,…

Q: A channel is used as a tension member with the web of the channel welded to a 9.5 mm thick gusset…

A: To solve these problems, we'll use the Load and Resistance Factor Design (LRFD) approach. LRFD…

Q: Water at 25°C is pumped into the galvanized iron pipe branch consisting of two 50-mm-diameter pipes…

A:

Q: A 4.0 m thick layer of fill material is to be placed on the ground surface of the soil profile shown…

A: H = 4 m = 20.2 kN/m3

Q: Solve and draw shear force and bending moment for this beam

A: Given Concentrated moment 25 kNmUDL 10 kN/mSpan 6 mTo find out SFD BMD

Q: What reduction factor are we going to use if p > Pb a. 0.9 b. 0.65 C. 0.45 d. Ø= 0.65 +0.25 Ey - Et…

A:

Q: am 140 mm mm 140 mm 34 -X

A:

Q: What is the remedial measure fir a failed landfill liner

A: We need to explain remedial measure for a failed landfill liner

Q: Derive and plot 3-hour Unit hydrograph for a stream which drains an area of around (401) km2.…

A:

Q: (n) 1,6k(1 30¹ # 40' AD Draw show & Moment diagrams A ZO #

A:

Q: Consider the beam in (Figure 1). Take that w = 7 kN/m. Determine the normal force, shear force, and…

A:

Q: 2.7 The following are the results of a sieve and hydrometer analysis. Analysis Sieve Hydrometer…

A: (a)Draw the calculation table as shown below.Sieve no/grain sizeDiameter mmPercent finer…

Q: What does the moment diagram look like 分 1 24 P →>> H An L

A:

Q: 6-22. The beam is subjected to a uniform live load of 1.2 kN/m, a dead load of 0.5 kN/m, and a…

A: Given Span 16 mDead load = 0.5 kN/mLive load = 1.2 kN/m and 40 kNTo find out Maximum positive shear…

Q: 6.10 Refer to Figure P6.5a. The uniform surcharge is time dependent. Given q (kN/m²) = 2t (days)…

A: Given surcharge,

Q: ing characteristics and carries condition, determine the tota

A: Number of Lanes = 4Shutted down lanes = 2 Volume of traffic = 4250 veh/hrTime to clear obstruction =…

Q: Draw the shear force and bending moment diagram for a simply supported beam of length 9 m and…

A:

Q: 1.-) Draw the shear force and bending moment diagrams for the beam. A 5 pies- 6 kip -6 pies- 12 kip…

A:

Q: Consider a five-sided closed polygon traverse. The azimuth of side AB is fixed at 218°59'30". A=…

A: Interior angle

Q: For the truss shown in the figure, the magnitude of the force (in kN) in the member SRis 30 kN I 1m…

A: The magnitude of the force (in kN) in the member SR is =?

Q: 7. A specimen of soil was collected from a depth of 10 m in a deposit of clay. The ground water…

A:

Q: A 500-ft curve, 9₁ = -2.00%, 92 = +3.00 %, VPI station = 98 + 10, VPI elevation = 5388.26 ft,…

A:

Q: On the given beam, find the following unknowns using the slope-deflection method. Assume that E is…

A:

Q: The architects specify that a cover-plated beam no greater than 16.00 in in depth be designed to…

A: Span= 28 ftlive service uniform load= 6 klfFy= 50 ksi

Q: 3. A settling tank has an overflow rate of 100,000 gal/ft² d. Water carrying sediment of various…

A: Overflow rate = 100,000 gal/ft2settling velocitymass friction…

Q: 7.9 A specimen of soil was collected from a depth of 12 m in a deposit of clay. The ground water…

A: Given Depth 12 mLiquid limit 68Plastic limit 29Saturated unit weight 17.8 kN/m3Preconsolidation…

Q: wing most nearly gives the saving’s in lining per meter length of channel that could have been…

A: As per QnA guidelines, only first question will be covered

Q: P12.3. Draw the influence lines for the reactions at supports A and C, the shear and moment at…

A:

Q: Determine the reactions of the structure. Determine the internal forces of each element, in kN.…

A:

Q: A 12.5 mm x150 mm plate is connected to a gusset plate having a thickness of 9.5 mm.Diameter of…

A: A 12.5 mm x150 mm plate is connected to a gusset plate having a thickness of 9.5 mm.Diameter of bolt…

Q: 20' B hinge C 8 R₁, Re M. and V 10' D 10' E Draw an influence line for reaction at A and determine…

A:

Q: code limitation of L/240. 3/ If maximum deflecti

A:

Q: A concrete sewer pipe has a cross-sectional area of flow of 0.11045 m2 and a flow velocity of 3.45…

A: Area of flow (A) = 0.11045 m2Flow velocity (V) = 3.45 m/s Determine the flow rate (Q).

Q: A tension member consists of a double angle section with long legs back to back. The angles are…

A:

Steel Framing

A steel frame consists of a skeleton frame structure comprising of horizontal I-beams and vertical steel columns fitted in a rectangular grid building construction to brace the floors, walls, and the roof of the building held onto the frame. Due to the implementation of this methodology, the construction of the skyscrapers was feasible.