tem : TLO : Points: TLO 1 14 pts An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle source is then impressed across the combination. If the voltage drops across the coil and the fixed resistor are 70 and 80 V, respectively, when the circuit curent is 1.4 A, calculate the resistance and inductance of the impedance coil. Ihem TLO Points

tem : TLO : Points: TLO 1 14 pts An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle source is then impressed across the combination. If the voltage drops across the coil and the fixed resistor are 70 and 80 V, respectively, when the circuit curent is 1.4 A, calculate the resistance and inductance of the impedance coil. Ihem TLO Points

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 1RQ: 1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive...

See similar textbooks

Similar questions

50. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: a. Ohmic value of the resistor b. Capacitive reactance E. capacitance in microfarad
54. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following series resistances and reactances: R1=10 ohm, R2= 15, XL1=20 ohms, XL2=25 ohms, XC= 40 ohms. Find the following a. Equivalent reactance b. Total impedance c. Voltage drop across the capacitor
Two impedances consist of resistance of (15 ohms and series connectedinductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henryand a capacitance of 100 microfarad, all in series) are connected in series andare connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltageacross each impedance, (c) individual and total power factor. Draw the phasordiagram.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. What is the minimum AC voltage rating of each capacitor? Answer is 1200 volts. What is the current flow through the circuit? And what is the minimum kVAR rating of each capacitor?
A line consist of a pure resistance and a coil in series. The power dissipated in the resistance is 500 Watts and the drop across it is 100V. The power dissipated in the coil is 100 Watts and the drop across it is 50 V. What is the voltage at the sending end?
In the circuit in Figure 2, the capacitor connected to the a-b terminals of the transformer anda circuit consisting of resistance is defined as a load circuit. a)Find the average power spent by the load circuit? b) How much of the average power calculated in a) by the resistance in the load circuit and how muchspent by the capacitor? Comment on the results obtained?
When a voltage of 100 volts at 50 Hz is applied to an impedance coil A, the current taken is 8 A and the power is 120 watts. When applied to an impedance coil B, the current is 10 A and the power is 500 watts. What current and power will be taken when 120 V, 60 Hz is applied when the two coils are connected in parallel?
An ac resistance is higher than a dc resistance. True False
1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive circuit?
60. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following series resistances and reactances: R1=10 ohm, R2= 15, XL1=20 ohms, XL2=25 ohms, XC= 40 ohms. Find the real power. a. 65.3899 b. 392.4372 c. 397.848 d. 588.6559
2. An inductive reactance of 8 0 is connected in parallel with a capacitive reactance of 18 N; this combination is then connected in series with a variable resistance. For what value of resistance will the power factor be 0.5, and what current will the circuit takes if the impressed voltage is 118 volts?
An impedance coil takes 10A and absorbs 250 W when connected across a 220V, 60Hz source. What power will it absorb when connected across 110 V, 25 Hz mains? a. 539 W b. 239 W c. 439 W d. 339 W