Why is the circuit critically damped? Explain.

Q: A short circuit test was performed upon a 10-kVA, 2300/230-volt transformer with the following resul...

A: Short circuit test is performed on high voltage side with low voltage side short circuited. Here hig...

Q: Given the circuit below, calculate the voltage drop across R2 when the voltage on each LED is 3 volt...

A:

Q: A 22 uf capacitor has a charge of 250 uc stored on it. What is the voltage across the capacitor?

A: Here, we have given a condition, we have to calculate the voltage across the capacitor, when the cap...

Q: In the series combination of a 300 ohm resistor, 0.25 H inductor, and a 1 microfarad capacitor, find...

A:

Q: What is CMOS Circuit Characterization?

A:

Q: (c) Figure 3(c) shows a three-phase, positive sequence A-A connected circuit with a line impedance o...

A:

Q: If a communication bandwidth of Bc= 20,000 Hz is available how many bits, n, per signal clement are ...

A: The bit rate and the bandwidth of the signal are known. For the perfect  noiseless channel, the bit ...

Q: Problem 4. Let the components of the vector x = [r1,., Ta]' be binary-valued (0 or 1), with d odd, a...

A:

Q: A single phase alternator gives 250 A at 1200 volts. What is the output of the machine in kVA?

A:

Q: In the circuit shown in the figure below, if the continuous resistance of the coil is 45 ohms and th...

A:

Q: A series circuit consisting of a variable resistor in series with a capacitance of 80 microfarad is ...

A: Power consumed by resistor = current2 × resistance . First write the expression for current in the c...

Q: the Dc lood tire par the Pollwinas Ciruib っU

A: Solve the problem

Q: 1.3 Support that we use PORTA to read external inputs from switchers. When both Switch 1 and Switch ...

A:

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH nductance. What is...

A:

Q: A DC shunt motor runs at a speed of 1000 RPM on no load taking a current of 6 A from the supply, whe...

A: DC shunt motor A shunt motor has a field winding parallel to the armature winding. It is a self-exci...

Q: (C) VD and Vs- (d) VDs- 20. For the voltage-divider configuration of Fig. 6.84, determine: (a) Ipo a...

A: Brief description:  Generally the current flowing into the gate terminal of the MOSFET is zero amper...

Q: Cut-off region occurs when .18 Vgs Vth O Vgs = 0 O %3D

A: The explanation is as follows.

Q: Question 1 Based on your knowledge of these following Electromagnetic Theorems and Laws, discuss FIV...

A:

Q: Derive the hazard free Boolean expression for given logic function. F(W,X,Y,Z)=m(0,4,5,10,11,13,1415...

A: The given expression is in the SOP (sum of products) form. 0 - 0000 4 - 0100 5 - 0101 10 - 1010 11 -...

Q: 2. Calculate l, in the 2ohms resistor using Norton's Theorem. 10 A 20 V 0לל load

A:

Q: what are the draw back of using DTOC relays for the protection of long feeders?

A: Relay: The main work of relay is used to detect the fault and send the signal to the circuit breaker...

Q: Q5 (a) The unknown low-value resistance (R,) was measured using an ammeter-voltmeter method with a v...

A:   5) (a) Low value resistance measurement using ammeter- voltmeter method  To calculate the actual v...

Q: (Ъ) An ammeter shown in Figure Q.1b(i) with full scale current of PMMC is 100 µA and internal resist...

A: The solution is given below 

Q: 21. Given a capacitance of 30 nF and a voltage of 30 J, compute for the charge and energy.

A:

Q: For the purely resistive circuit, do the voltage drops add up algebraically, e.g., 1+3+6=10? How abo...

A: solve...

Q: 8. A 15.9-µF capacitor and a 15.1-mH inductor are connected in parallel. In series with these units ...

A:

Q: The Thevenin’s Resistance, Rth external to R2 of the figure shown is

A:

Q: What is the voltage and total power for the following circuit?

A: In this question we will find total voltage and total power in following circuit...

Q: 5. Find the unknown currents in the curcuits shown in Fig. 2.40 (a). DC Network Theorems 4A 8A SA 5A...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: nswer the following and show complete solutions. Instructions: 2. Using the Residential rate schedul...

A:

Q: The magnetic force acts on the wire 2 -5 cm→ 20 A 5 A 10 cm 2 cm 0.1 mN 0.0286 mN None of the choice...

A: Given circuit:  

Q: A. The instantaneous If the rms values of voltage and current are 120 V and e power is, (a) 120-/2 c...

A: Instantaneous power Instantaneous power absorbed by an element is defined as the product of the inst...

Q: What types of fuses are heavy-duty time delay fuses used for circuits that have motor loads or circu...

A: In this question we will write fuses used for motor loads....

Q: Q1. The system impulse response is given as u[-n-3]. Check if the system is i. with or without memor...

A: Causal System: If the output of the system is independent of the future value of the input then the ...

Q: A coil that is wound around an iron bar with 5 m length, and are of 2.5 m2, creates a field intensit...

A: From given reluctance calculate permeability and relative permeability.  Mmf = H × mean length of th...

Q: What is ohms low

A: OHM'S LAW: The link between the electric current & the potential difference is described by Ohm'...

Q: 2) Consider the circuit shown. a) Find the current in the 10 2 resistor with the switch open. b) Fin...

A: In this question , we will find current through resistors when switch close and switch is open....

Q: For two charges Q, at (4,0,-3) and Q, at (2,0,1), find Q, if Q, = 4 nC for forceF at (5,0,6) has no ...

A:

Q: ductance 1 henry and resistance 10 ohms is connected in series with an e.m.f of Eo sin 10 t volts. W...

A:

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a know...

A:

Q: (c) (i) When 10100 is input to a 5-bit digital-to-analog converter, the output current is 10 mA. Wha...

A: Since you have asked multiple questions , we will solve the first question for you . If you want any...

Q: If Vy 0.7 V for the diode in the circuit in Figure below, determine ID and VO. +15 10 kΩ Ip o Vo 20 ...

A:

Q: In the figure below, find the range of load resistance values that maintain a zener voltage of 10v e...

A: The solution is given below 

Q: A series circuit with 2 amperes flow through a 20 ohm resistor, 50 ohm inductive reactance. What is ...

A: Apply KVL in loop to find supply voltage.  According to KVL sum of voltage rises and voltage drops i...

Q: Find the input impedance of circuit shown at w = 10 rad/s. 0.5 mF 80 Q 8 H el Zin 1 mF 200 Q Answer:...

A: we need to find the corresponding reactances of capacitors and inductors at the given angular freque...

Q: A bacterial population Y is known to have a rate of growth proportional to Y itself. If between noon...

A:

Q: A boost converter has an input voltage Vb=5V. The average load current is lo=0.5A. The switching fre...

A:

Q: Write the Fourier expression for the first six non-zero sinusoidal terms for the waveform shown in t...

A: Given the signal as shown below: We need to find the Fourier series of the function. T=0.5 ms ωo=2π...

Q: 8. distance that will be created between the foil The greater the charge, the lesser the strip. 9. W...

A: 8) False Greater charge not lesser the distance that creat between the foil strip 9)True We can dete...

Q: of 4 Page < Figure P6.25 P6.59. Solve for the transfer function H( f )= V out / V in Also determine ...

A: In this question we will find transfer function of given low pass filter and find out its cut off fr...

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.